No hammers, nails, screws, or stud finders are needed.
A electric miter saw (a chopsaw, band saw or tablesaw) is not required but is recommended for making accurate cuts and invisible seams.
|
||
 |
 |
 |
1.
Survey your room/count corners
|
2.
Find correct angle of corner
|
3.
Order inside and outside corners and molding
|
 |
 |
 |
7.
Measure length between corners
|
8.
Cut with a saw or kitchen knife
|
9.
Apply adhesive and mount
|
10. Touch up joints and seams with shrink-free spackle or painters acrylic caulk |
Caulk top and bottom of crown mold for a better look Touch up with a finish coat of paint on the joints A good tip is to smooth caulk with a finger wet with water |
Your are done!
painting tips
|
 |
 |
 |
Paint Recommendation:
After careful testing we have found that ICI paints save time and dry with a smooth finish.
Only 1
coat of Gripper® and 1 coat of topcoat
is needed with these paints. Choose either Glidden® Ultra-Hide® Latex
or Dulux® Advanced
Alkyd.
ask for:
Gripper® Primer/Sealer (3210) and
Glidden® Ultra-Hide® Latex semi-gloss enamel paint (1416) or
Dulux® Advanced
Alkyd paint (1508 gloss or 1506 semi-gloss)
Ask for your Creative Crown™ national
discount (a discount card will be available in July 2006). It's
good for all ICI products
in all company owned stores and some ICI independent dealer stores.
If you aren't close to an ICI store, you can purchase Gripper (3210) and Glidden Ultra-Hide latex paint in most Home Depot stores.
To
locate an ICI store near you 
®
Creative Crown Molding
of Dallas © 2005 - 2008
880 N Dorothy Dr. #808
Richardson Texas 75081
(972) 907-0101
(888) 442-6662
